Before installing laminate flooring over concrete, prepare the surface properly. Remove baseboards and molding. After ensuring that the floor is level, install the moisture barrier sheeting of polyethylene film, overlapping the edges by 8 inches. Tape the seams using a polyethylene tape. Some laminate flooring comes with a foam backing.
The next thing we asked ourselves was; how to install a laminate floor?
Lowe’s has many styles of laminate floors to fit any home, including Pergo ® Timber. Craft™ Plus Wet. Protect, which is waterproof and protects against spills and pet accidents. Finishing up, installation, prep the floor, and before installing laminate, first prepare the subfloor interesting too.
This begs the inquiry “How to prepare your floor before installing laminate flooring?”
Before you begin the actual installation of your new laminate floor, you have to prep the existing floor. First off, the subfloor should be flat. If it’s made of concrete, grind off any high spots. Low spots should be filled with leveling compound. All carpeting and carpet padding should be removed unless the carpeting is a quarter-inch (6 mm.
Laminate floor systems do not function well on uneven surfaces. Before starting any flooring work, inspect the subfloor. Crawl around with a straightedge to find any areas that are more than 1/8-inch high or low. Subfloor seams are the usual suspects.
Where to start laying laminate?
Part 2 Part 2 of 2: Laying Down the Boards. Place the first board. Place a board at the top left corner, finished side up, ridge side facing the wall., and place spacers. Wedge a spacer between the end and edge of the board and the wall. Move on to the second row, trim planks which don’t fit into the remaining spaces, continue until each row is done, or repeat for the second board in addition will be important too.
Where to start laying floor?
There is a wide range of different floor tiles. Now that your surface is prepped for tiling, the next step is to decide the arrangements of your tile (its layout)., and cutting tiles. A few more ideas to look into: lay down tiles, apply bond, or grout joints.